Design Analysis Questionnaire

We hope you find this a helpful tool for considering and sharing the information on your project. Please feel free to print this page for reference or you can fill it out and send it for our review.

ETI is always available to assist answering questions or discussing options. We are here to assist with this form or if you wish to send a drawing or electronic part model. Please contact us at 800 660-0420 or by email customerservice@etiroltec.com. File transfer from your secure file transfer protocol site is also available.

Tell us about your parts purpose.

Seal Fluid
Transmit Fluid
Absorb Energy
Transmit Energy
Structural Support
Medical Part
Dental Part
Special Performance Objectives
Cost Objective Defined

What environmental conditions will your part encounter?

Ambient, non-critical application
Water
Sea Water
Solvents
Chemical
Oxygen
Ozone
Other Gases
Wet
Dry
Constant Pressure
Dynamic Stress
Temperature
Abrasives
Sunlight
Ultraviolet Light
Sterilization
Vacuum
Body Contact

Material Properties Review

Have you selected a material and material hardness?

Are there additional requirements such as stretch, tear resistance, deformation resistance to setting under compression, or must the part resist dimensional change with temperature or fluid exposure?

Does your part design define or review the following information:

Tolerances
Corner Radii
Square edges
Undercuts
Flatten (.010”) Feather Edges and Sharp Edgs
Insert Drawing
Insert Material

Insert-molding review: Adhesive bonded Mechanical bonded Both

Multi-color Requirement
Pad Print
Hot Stamp
Coating
Flash Requirement
Gate Location and Remnant
PMS Color Specification

Provide Specific Instructions From Checklist:

Have you selected a process for your part?

Compression
Transfer
Liquid Injection Molding
Die Cutting or Stamping
Fabrication, Sewing or Slitting
Other

Have you defined your quality requirements?

AQL Inspection Level
Special Testing
Special Tolerances
Special Part Features
Special Process Contols
Design of Experiments
Special Jigs and Fixtures
Special Inspection Equipment Required
Special Certification Required

Please provide details on any additional information we should consider.

Estimate your annual part order requirements:

Contact Information (required):

Company

Your Name

Email Address

Telephone

Please send me a quote for this part.

We hope you find this a helpful tool for considering and sharing the information on your project. ETI is always available to assist answering the questions or discussing options. Additionally we are here to assist in transferring the form or if you wish to send a drawing or electronic part model. Please contact us at 800 660-0420 or by email customerservice@etiroltec.com File transfer from your secure file transfer protocol site is available.